Tc-electronic FireworX User Manual download pdf (Page 48)

SYSTEM & MIDI Utility

The Utility display

In the Utility display, you can choose between Config.

and Card. Use the < > Arrow keys to select between

the two displays.

The Config. Page

In the Config. page you can set up a number of global parameters

for the FireworX such as memory protect, MIDI bulk dump etc.

Viewing Angle

Adjust for best contrast of the LCD display.

Sticky Tempo page

Determines whether the Tempo page sticks on until another key

is pressed or disappears automatically after a few seconds.

Param. dial direction

This parameter enables you to change the cursor direction when

dialing the Parameter wheel. Choose whether the cursor should

move up or down when dialing the parameter wheel clockwise.

DSP load check mode

Selects the repsonse of the FireworX when the DSP limit is

exeded. When set to “Secure”, the outpus of the FireworX will

be muted when the DSP power limit is exeded. When set to

“Free”, the FireworX will continue to play, however the sound is

must likely to be corupted until

you reduce the number of

effect blocks in the Routing.

Pedal Type

Switches between momentary

and alternating. This parameter

should be set to alternating if

you are using an expression

pedal.

Pedal Calibration

Press Enter to enable

calibration of the External

input jack on the back panel of

the FireworX. Follow the

instructions in the display.

Protect

Sets the Preset Protect function On/Off.

Protect Low limit

Sets the lower limit of the Preset protect. The current number is

included in the protection.

Protect High limit

Sets the higher limit of the Preset protect. The current number is

included in the protection.

MIDI Bulk Dump

You can backup the User Presets of the FireworX to another

FireworX or to MIDI recording device using these functions.

User Bank to MIDI

Connect your FireworX’s MIDI Out to another FireworX, a

sequencer or any other MIDI recordable device. Press Enter

twice and the FireworX will perform a MIDI bulk dump of all

User Presets.

MIDI to User Bank

Connect the storing device to the FireworX’s MIDI In and press

Enter. The FireworX is now ready to receive a MIDI bulk dump

containing User Presets.

WARNING: This action will overwrite ALL existing User Presets

in the FireworX.

The Card page

The Card page features a number of tools for handling Cards,

including Preset copying to and from Card.

Use the Parameter wheel to scroll, and the Value wheel to change

values. Card type: SRAM PCMCIA, type 1, min. 64 K byte.

Show Card status

This function makes it possible to check the status of your PC-

Card. The FireworX will be able to display the size of the card,

the write protection status, the number of Presets on the Card and

the amount of free space.

NOTE: This information will only be available when the card is

FireworX formatted or contains FireworX Presets. The FireworX

will read “New Card” when the Card is inserted if the Card is not

formatted.

Config

Display Viewing Angle

Sticky Tempo page

DSP Load check Mode

Pedal calibration

Pedal type

Protect

Protect Lo-limit

Protect Hi-limit

User Bank to MIDI

MIDI to User Bank

MIDI Bulk dump

User Bank protect

Environment

User Interaction

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 81 82

Comments to this Manuals

No comments

Tc-electronic FireworX User Manual Page 48

Comments to this Manuals

Related products and manuals for Audio accessories Tc-electronic FireworX