Tc-electronic BG250 User Manual download pdf (Page 18)

Operation – Rear Panel

9. MAINS IN –

Power switch & Power input

The switched-mode power supply of this device ac-

cepts voltages from 100V to 240V. The ground pin of

the power supply unit must always be connected in

order to avoid voltage differences between e.g. the PA

and the BH250 / BG250-208.

10. PEDAL input

You can connect a TC Electronic Switch-3 to the PED-

AL input of your BH250 / BG250-208 to control the fol-

lowing features:

■ ActivateTonePrintA

■ ActivateTonePrintB

■ Mute

11. USB port

To transfer a downloaded TonePrint from your comput-

er to your TC device, connect the computer and your

TC device using a USB cable. A USB connection can

also be used to update the internal software (firmware)

of the TC device.

12. SPEAKER OUT

Use the SPEAKER OUT connector for connecting

BH250 to speaker cabinets. Please note that this is a

speakON connector, and you must use speaker cables.

Do not use instrument cables!

Use a cabinet configuration with your BH250 with a

minimum load of 4 Ohms. Examples:

■ 2x8Ohm(inparallel)

■ 1x4Ohm.

13. AUX IN

The AUX IN is a stereo auxiliary input. Any signal

present on the AUX IN jack is played back through all

BH250 / BG250-208 outputs. This allows you to play

along with a rehearsal track, or you can practice to the

beat of a metronome click. The included “mini jack to

mini jack cable” allows you to use an iPod®, iPhone®

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 24

No comments

Tc-electronic BG250 User Manual Page 18