■
Using TonePrint Editor
TC Electronic TonePrint Editor
■
Manual for software version 1.0 7
With TonePrint Editor, you decide what parameter
range you want to control, and how the knob’s po-
sition should affect it. If you want to, you can even
use the knob range left of the center position to go
from 0 to 100 % – and then back to 25 % when
turning the knob all the way clockwise.
Assigning parameters to a knob
■
Start by selecting a knob in the Knob Selection
section.
The selected knob will be highlighted.
■
Select one of the three yellow, red and blue
“LEDs”.
The selected LED will be highlighted.
■
Select a parameter you want to control from
the drop-down menu to the left of the LED.
■
Turn the knob to see its current position high-
lighted in the graphical “Peak Performance” in-
terface.
As you can see, you can assign up to three pa-
rameters to a knob. The currently selected pa-
rameter will be highlighted in the display, with the
other parameters still visible in the background.
Scaling the selected parameter is described in
the next section of this manual.
Modifier display
In the upper left part of the TonePrint Editor win-
dow is small graphical interface where effect val-
ues assigned to the currently selected knob are
represented by “peaks” and “valleys”. This display
is your key to understanding and controlling the
way your pedal’s knobs control effect parameters.
Before you can define the relationship between
knob positions and parameter values, you have
to select the parameter in the Knob Selection
section.
Once you have selected a parameter, the modi-
fier curve for that parameter will be shown in the
Modifier display. By default, this is a straight line
from the parameter’s lowest value in the lower left
corner to the maximum value in the upper right
corner.
Comments to this Manuals